SEMI CROSSDRAFT BOOTHS
The Semi Crossdraft booth intakes fresh air through the cleaner upper level of the shop, through a bank of filters in the ceiling near the product doors. The filtered air is drawn down and across the length of the booth, through a filtered exhaust system at the back. The booth is available in solid back, drive through, and reverse flow designs.

FULL DOWNDRAFT BOOTHS
This very efficient booth design intakes fresh air from the cleaner upper levels of the shop, through filter banks in the ceiling. The clean filtered air is then drawn down and around the product, through a filtered exhaust system pit in the floor underneath. This design tends to keep overspray away from unprepped product areas, and also away from the painter and other painters in the booth. The booth is equipped with an air supply plenum and is available in both solid back and drive through designs.

SIDE DOWNDRAFT BOOTHS
This Side Downdraft booth offers most of the full downdraft booth benefits without an expensive downdraft exhaust pit. Fresh air is brought in through the cleaner upper levels of the shop, through filter banks in the ceiling of the booth. The clean filtered air is drawn down and away from the product through exhaust filters at the floor level along both sides of the booth. The overspray is pulled away from other parts of the product and from other painters in the booth. This booth is equipped with an air supply plenum and is available in both solid back and drive through designs.

AIR REPLACEMENT UNITS
All Truck Trailer and Equipment booths can be equipped with air replacement units that control inside air pressure, temperature and cure cycles to meet your requirements.

LIGHTING FEATURES
Bright full booth illumination is provided by four tube, 48" 40 watt florescent light fixtures in the angled ceiling panels and side walls. Each is mounted behind clear tempered safety glass and sealed with a trimlock gasket. All fixtures are UL listed and approved for their intended use and placement. The light tubes are not furnished with the fixtures.

CONSTRUCTION FEATURES AND QUALITY STANDARDS
All booth and plenum sections are made with 18 gauge galvanized steel. All product and personnel access doors are double skinned for ease of maintenance, and treated for noise control. Panic latches and limit switches are provided for each door opening. All Truck Trailer and Equipment booths are rigidly reinforced with external "I" beams.

All exhaust fan units are equipped with TEFC motors and sized for more adequate air flow movement to meet all quality code standards. The control panels and other electrical components are to be supplied by others. All hardware, filters and sealants needed for the booth installation are included.

PAINT & CURE Spray Booth products comply with all NEC, OSHA and NFPA regulations. There will be no surprise additions required to meet the codes.